Thông tin chi tiết sản phẩm:
Thanh toán:
|
XENPAK MSA: | Compatible | Connector: | SC Receptacle |
---|---|---|---|
Wavelength: | 1310nm DFB Laser | Power: | +3.3V, APS(+1.2V) |
Interface: | MDIO 2-wire | 70-PIN Connector: | Support |
Điểm nổi bật: | sfp bidirectional transceiver,fiber optic transceiver module |
XENPAK 10GBASE-LR SC 1310nm DDM SFP Optical Transceiver Module
Features
Applications
Absolute Maximum Ratings
Parameter | Symbol | Min | Max | Unit | Ref. |
Storage Ambient Temperature Range | -40 | +85 | °C | non condensing | |
Powered case Temperature Range | 0 | +70 | °C | non condensing | |
Adaptable Power Supply (APS) | Vapsense | 0 | 1.5 | V | Voltage @ Pin APS Sense |
Supply Voltage Range @ 3.3V | Vcc3 | -0.5 | 4.0 | V |
Any stress beyond the maximum ratings can result in permanent damage. The device specifications are guaranteed only under the recommended operating conditions.
Operating Conditions
Parameter | Symbol | Min | Typical | Max | Unit | |
Operating Case Temperature | Tc | 0 | +70 | °C | ||
Power Supply Voltage | VCC3 | 3.14 | 3.3 | 3.47 | V | |
VAPS | 1.152 | 1.2 | 1.248 | |||
Power Dissipation | PD | 3.5 | W |
Optical Interface
Transmitter Characteristics
Parameter |
Symbol |
Min. |
Typ. |
Max. |
Unit |
Note |
Operating Range |
|
|
|
10 |
Km |
|
Operating Date Rate | 10.3125 | Gb/s | ||||
Average Optics Power | Po |
-8.2 |
|
0.5 |
dBm | |
Input Centre Wavelength | λ | 1260 | 1310 | 1355 | nm | |
SMSR. | SWSR | 30 | dB | |||
Extinction Ratio |
ER |
3.5 |
|
|
|
|
Optical Modulation Amplitude |
OMA |
500 |
|
|
µW |
|
Transmitter and Dispersion Penalty |
TDP |
|
|
3.2 |
dB |
|
Parameter |
Symbol |
Min. |
Typ. |
Max. |
Unit |
Note |
Operating Date Rate | 10.3125 | Gb/s | ||||
Average Optics Power | Po |
0.5 |
|
|
dBm | |
Sensitivity in OMA | OMA0 | -12.6 | dBm | |||
Stressed Sensitivity in OMA |
OMAst |
|
|
-10.3 |
dBm |
|
Sensitivity MINI |
Pmin |
|
|
-14.4 |
dBm |
1 |
Note :
1. Measured at 10.3125Gb/s,Non-framed PRBS2^31-1,NRZ
XAUI I/O Characteristics
Parameter | Symbol | Min. | Typ. | Max. | Unit | Note |
XAUI Date Rate | DR | 3.125 | Gb/s | |||
XAUI Baud Rate Tolerance | -100 | +100 | ppm | Relative Tolerance | ||
Differential Input Voltage Swing | 220 | 1600 | mv | 8B/10B Coded Input Signal | ||
Differential Output Voltage Swing | 800 | 1600 | mVp-p | RLOAD = 100Ω ± 5% | ||
Differential Input Impedance | 80 | 100 | 120 | Ω | ||
Total Output Jitter | TJXAUI | 0.35 | UI | no pre-equalization | ||
Total Deterministic Output Jitter | DJXAUI | 0.17 | UI | no pre-equalization |
Signal Specifications – Electrical
Parameter | Symbol | Min | Typ | Max | Units |
1.2 V CMOS | |||||
Input High Voltage | VIL(MAX) | - | - | 0.36 | V |
Input Low Voltage | VIH(MIN) | 0.84 | - | 1.25 | V |
Capacitance | - | - | 320 | pF | |
Pull Up Resistance | Rpull | 4.7k | 10k - | 22k | ohm |
MDIO I/O | |||||
Output Low Voltage | VOL | -0.3 | - | 0.2 | V |
Output Low Current | IOL | - | - | 4 | mA |
Input High Voltage | VIH | 0.84 | - | 1.5 | V |
Input Low Voltage | VIL | -0.3 | - | 0.36 | V |
Pull-up Supply Voltage | VPULL | 1.14 | 1.2 | 1.26 | |
Input Capacitance | CIN | - | - | 10 | Pf |
Load Capacitance | CLOD | - | - | 470 | Pf |
External Pull-up Resistance | EPULL | 200 | - | - | Ohm |
Pin Definitions
Pin No | Name | Dir | Function | Notes |
1 | GND | Electrical Ground | 1 | |
2 | GND | Electrical Ground | 1 | |
3 | GND | Electrical Ground | 1 | |
4 | 5.0V | Power | 2 | |
5 | 3.3V | Power | 2 | |
6 | 3.3V | Power | 2 | |
7 | APS =1.2V | Adaptive Power Supply | 2 | |
8 | APS =1.2V | Adaptive Power Supply | 2 | |
9 | LASI |
Open Drain Compatible 10K-22K pull up on host. Logic High: Normal Operation Logic Low: LASI Asserted |
3 | |
10 | RESET | I |
Open Drain compatible. 10-22K pull-up on transceiver Logic high = Normal operation Logic low = Reset Minimum reset assert time 1 ms |
3 |
11 | VEND SPECIFIC |
Vendor Specific Pin. Leave unconnected when not in use. |
6 | |
12 | TX ON/OFF | I |
Open Drain compatible. 10-22K pull-up on transceiver Logic high = Transmitter On (capable) Logic low = Transmitter Off (always) |
3 |
13 | RESERVED | Reserved | 3 | |
14 | MOD DETECT | O | Pulled low inside module through 1k | |
15 | VEND SPECIFIC |
Vendor Specific Pin. Leave unconnected when not in use. |
6 | |
16 | VEND SPECIFIC |
Vendor Specific Pin. Leave unconnected when not in use. |
6 | |
17 | MDIO | I/O | Management Data IO | 3, 4 |
18 | MDC | I | Management Data Clock | 3, 4 |
19 | PRTAD4 | I | Port Address Bit 4 (Low = 0) | 3 |
20 | PRTAD3 | I | Port Address Bit 3 (Low = 0) | 3 |
21 | PRTAD2 | I | Port Address Bit 2 (Low = 0) | 3 |
22 | PRTAD1 | I | Port Address Bit 1 (Low = 0) | 3 |
23 | PRTAD0 | I | Port Address Bit 0 (Low = 0) | 3 |
24 | VEND SPECIFIC |
Vendor Specific Pin. Leave unconnected when not in use. |
6 | |
25 | APS SET | Feedback input for APS | ||
26 | RESERVED | Reserved for Avalanche Photodiode use. | 6 | |
27 | APS SENSE | APS Sense Connection | ||
28 | APS =1.2V | Adaptive Power Supply | 2 | |
29 | APS =1.2V | Adaptive Power Supply | 2 | |
30 | 3.3V | Power | 2 | |
31 | 3.3V | Power | 2 | |
32 | 5.0V | Power | 2 | |
33 | GND | Electrical Ground | 1 | |
34 | GND | Electrical Ground | 1 | |
35 | GND | Electrical Ground | 1 | |
36 | GND | Electrical Ground | 1 | |
37 | GND | Electrical Ground | 1 | |
38 | RESERVED | Reserved | ||
39 | RESERVED | Reserved | ||
40 | GND | Electrical Ground | 1 | |
41 | RX LANE0+ | O | Module XAUI Output Lane 0+ | 5 |
42 | RX LANE0- | O | Module XAUI Output Lane 0- | 5 |
43 | GND | Electrical Ground | 1 | |
44 | RX LANE1+ | O | Module XAUI Output Lane 1+ | 5 |
45 | RX LANE1- | O | Module XAUI Output Lane 1- | 5 |
46 | GND | Electrical Ground | 1 | |
47 | RX LANE2+ | O | Module XAUI Output Lane 2+ | 5 |
48 | RX LANE2- | O | Module XAUI Output Lane 2- | 5 |
49 | GND | Electrical Ground | 1 | |
50 | RX LANE3+ | O | Module XAUI Output Lane 3+ | 5 |
51 | RX LANE3- | O | Module XAUI Output Lane 3- | 5 |
52 | GND | Electrical Ground | 1 | |
53 | GND | Electrical Ground | 1 | |
54 | GND | Electrical Ground | 1 | |
55 | TX LANE0+ | I | Module XAUI Input Lane 0+ | 5 |
56 | TX LANE0- | I | Module XAUI Input Lane 0- | 5 |
57 | GND | Electrical Ground | 1 | |
58 | TX LANE1+ | I | Module XAUI Input Lane 1+ | 5 |
59 | TX LANE1- | I | Module XAUI Input Lane 1- | 5 |
60 | GND | Electrical Ground | 1 | |
61 | TX LANE2+ | I | Module XAUI Input Lane 2+ | 5 |
62 | TX LANE2- | I | Module XAUI Input Lane 2- | 5 |
63 | GND | Electrical Ground | 1 | |
64 | TX LANE3+ | I | Module XAUI Input Lane 3+ | 5 |
65 | TX LANE3- | I | Module XAUI Input Lane 3- | 5 |
66 | GND | Electrical Ground | 1 | |
67 | RESERVED | Reserved | ||
68 | RESERVED | Reserved | ||
69 | GND | Electrical Ground | 1 | |
70 | GND | Electrical Ground | 1 |
Người liên hệ: Mr. Michael Guo
Tel: 19928768315
Fax: 86-755-8312-8674
E-Link Gigabit Power Over Ethernet In phun 12 ~ 48VDC Đầu vào DIN Rail / Wall Mount
Cổng đơn 60W Cấp nguồn qua các thiết bị Ethernet Hỗ trợ Cài đặt Din Rail / Wall Mount
10/100 / 1000Mbps Công suất cao Poe In phun 95 watt 802.3bt Truyền 100m
48 Volt 2 Port Cisco POE Power Over Ethernet Injector 10 / 100 / 1000Mbps 15.4W
Bộ mở rộng quang Mini 4K HDMI Đầu vào USB đa chế độ không nén 300M
Bộ mở rộng sợi HDMI 4K SFP LC 80km Bộ mở rộng sợi quang đơn mode 10,3Gbps
SFP 5VDC HDMI qua Bộ mở rộng cáp quang Cổng Micro 4K USB 80Km
Bộ mở rộng cáp quang HDMI 4K * 2K HDCP 10,3Gbps SFP LC với âm thanh bên ngoài
Mini 3G / HD-SDI to Fibre Converter Extender với chức năng Tally hoặc RS485 Data
Bộ mở rộng video 3G-SDI SDI sang bộ chuyển đổi sợi quang qua đường truyền dài 20KM sợi quang
HD SDI To Fiber Optic Converter with Forward Audio
Ethernet over Fiber Converter SD/HD/3G-SDI + RS485/RS422/RS232 Data + 10/100M